Wireless Remote Control Differences between Telecrane and OHM

2017-04-07

Clescrane, we are not only providing the crane equipment, but also pay more attention on the choice of remote control. Compared with many suppliers, we are ensured OHM brand remote control after comprehensive evaluation, and established a long-term cooperation agreement. Compared with other Chinese crane suppliers who often choose Yu Ding brand remote control, the difference as follows:
1. Control way: OHM follows the highest EU standard, has the same real-time control function with HBC remote control. Once there is signal interference, the transmiting will be shutdwon automatically to avoid operation mistake. Telecrane uses one time sending. There is no connecting after the signal projector and receiver. Once there is wrong operation, the controller can not stop it. The crane working will be disturbed and even out of control.
2. OHM adopts two-stage molding with thermoplastic elastomer to achieve good shockproof and drop resistance. Telecrane has no such workmanship.
3. OHM has one independent intelligent key for each device. If there are two cranes on the same bay, when A controller is out of work, take out the key and plug it into B controller and then B controller can A crane.Telecrane has no this key.
4. OHM uses high-frequency module with stable signal transmitting. Telecrane uses crystal oscillator which is very cheap and with higher failure rate.
5. OHM uses the same metal dome for buttons with HBC controller, which has very long life. Telecrane does not have.